Filter
Top Products
[Audio output port (PC to Camera)]
Enter the transmission port number (the port number on the camera used to receive audio data transmitted
from the PC).
• Available port number: 1024-50000 (Only even numbers are available.)
• Default: 34004
Note
• The transmission port number entered for “Audio output port (PC to Camera)” will be used only when
“Unicast port (MANUAL)” is selected for “Transmission type” (®page 82, page 88).
When “Off” is selected for “H.264 transmission” (or “MPEG-4 transmission”) (®page 82, page 88) or
when “Unicast port (AUTO)” or “Multicast” is selected for “Transmission type”, it is not necessary to
enter the transmission port number.
[Permission level of audio trans./recep.]
Select an access level for audio transmission/reception from the following.
1. Level 1 only/ 2. Level 2 or higher/ 3. All users
• Default: 3. All users
Note
• Refer to page 156 and for further information about the access level.
[Muting while panning/tilting]
SW175
SW175
SW174W
SW174W
SW172
SW172
ST165
ST165
ST162
ST162
Select “On” or “Off” to determine whether or not to mute the camera's microphone when the camera is panning
or tilting. Select “On” to mute the noise from when the camera is panning or tilting.
• Default: On
Note
• When this function is set to “Off”, the microphone will be active when the camera is panning or tilting,
and noise from the panning/tilting may be picked up by the microphone.
Operating Instructions 131
11 Configure the settings relating to images and audio [Image/Audio]