Filter
Top Products
IMPORTANT
• Select “FTP error” for “Save trigger” on the [SD memory card] tab when using the SD memory card.
When “Alarm input” or “Manual” is selected for “Save trigger”, an alarm image will not be transmitted
at an alarm occurrence to the FTP server.
• When “3M Fisheye [4:3]” or “VGA Quad streams [4:3]” is selected for “Image capture mode”, images
cannot be transmitted to the FTP server.
Notify of alarm occurrences by E-mail
Alarm E-mail (alarm occurrence notification) can be sent at an alarm occurrence to the E-mail addresses
registered in advance. Up to 4 addresses can be registered as recipients of the alarm E-mail. An alarm image
(still picture) can be sent with the alarm E-mail as an attached file. The settings for alarm E-mail can be
configured in the “E-mail notification” section on the [Notification] tab of the [Alarm] page (®page 136) and
the [E-mail] tab of the “Server” page (®page 149).
IMPORTANT
• When “3M Fisheye [4:3]” or “VGA Quad streams [4:3]” is selected for “Image capture mode”, still images
cannot be attached and sent during alarm mail transmissions.
Notify of alarm occurrences to the designated IP addresses (Panasonic
alarm protocol notification)
This function is available only when a Panasonic device, such as the network disk recorder, is connected to
the system. When “On” is selected for “Panasonic alarm protocol notification”, the connected Panasonic device
will be notified that the camera is in the alarm state. The settings for Panasonic alarm protocol can be configured
in the Panasonic alarm protocol section of the [Notification] tab of the [Alarm] page. (®page 137)
38 Operating Instructions
4 Action at an alarm occurrence