Filter
Top Products
C3412M-D (12/08) 71
AUX
Note: If a 16X or 18X model dome drive is installed in a Spectra III SE or Spectra IV SE back box,
the auxiliary feature is functional and available. If a 16X or 18X model is installed in a standard
Spectra III or Spectra IV back box, the auxiliary feature is not available.
An auxiliary output is a programmable signal from the dome back box that can trigger another
device to operate. An auxiliary output is programmable to trigger from an alarm or from a controller.
An AUX 1 command from the controller will activate the relay in the dome and operate the device
that is connected to the relay. The output of AUX 1 can be connected to the alarm input of a
system switch to activate automatic monitor switching and recording.
An AUX 2 command from the controller will place a ground at the output of AUX 2 to operate the
device that is connected to it.
The following are the available AUX mode settings:
TOGGLE (default): Changes the state of the auxiliary output every time an AUX command
is received from the controller.
LATCHING: Must receive an AUX ON/AUX OFF command from the controller to turn the
auxiliary output on/off.
MOMENTARY: An AUX ON command from the controller turns the auxiliary output on for the
programmed DWELL TIME. The auxiliary output will automatically turn off when the dwell time
is finished.
EDIT SCHEDULE
The Edit Schedule menu is a duplicate of the Edit Event menu (refer to Event on page 80) with
the following exceptions. In the Edit Schedule menu, the event type cannot be changed. Also,
the Holiday feature cannot be accessed from the Edit Schedule menu.
For instructions on changing the features in the Edit Schedule menu, refer to Edit Event on
page 83.
EXIT
SPECTRA IV
LANGUAGE
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<TITLE TEXT>
<ALERT>*
<CLEAR>
<PASSWORD>
<CLOCK>
<EVENT>
DOME SETTINGS
BACK
EXIT
AUX 1 MODE TOGGLE
DWELL TIME (SECS) 1
AUX 2 MODE TOGGLE
DWELL TIME (SECS) 1
<EDIT SCHEDULE>
AUX
*This setting applies only to Pressurized Spectra IV dome systems.