Filter
Top Products
101
Shooting Functions
4
6
Point the remote control unit
towards the remote control
receiver on the front or back of
the camera, and press the shutter
release button on the remote
control unit.
The maximum operating distance of the
remote control unit is approximately 4 m
from the front of the camera and
approximately 5 cm from the back of the
camera.
After a picture is taken, the card access
lamp lights for 2 seconds and then
returns to blinking.
• By default, you cannot adjust the focus with the remote control unit. Focus on
the subject first with the camera before operating with the remote control unit.
When [9. AF with Remote Control] (p.68) is set to [On] in the [A Custom
Setting 2] menu, you can use the remote control unit to adjust the focus.
• When using the Remote Control Waterproof O-RC1, the autofocus system
can be operated with the S button. The { button cannot be used.
• Select a mode other than h, i or i in the Drive Mode setting screen to
cancel the remote control shooting. The setting is canceled when the camera
is turned off if [Drive Mode] is set to P (Off) in [Memory] (p.195) of the [A
Rec. Mode 3] menu.
• The Shake Reduction function is automatically turned off when h, i or i
is set.
• The remote control shooting may not be available in backlit conditions.
• The Remote Control F can send a remote control signal about 30,000 times.
Contact a PENTAX Service Center to replace the battery (this will involve a
fee).
4 m
5 cm