Philips HDC-TM20 Camcorder User Manual


 
23
VQT2B30
Caution:
When the SD card is removed while the access lamp is lit, this unit may malfunction or the data
recorded on the SD card may be lost.
1 Open the LCD monitor.
Check that the access lamp has gone off.
2 Open the SD card cover by
sliding the OPEN lever B.
3 Insert/remove the SD card.
Face the label side C in the direction shown in
the illustration and press it straight in as far as
it will go.
Press the centre of the SD card and then pull it
straight out.
4 Securely close the SD card cover.
Securely close it until it clicks.
Do not touch the terminals on the back of the SD card.
Do not apply strong shocks, bend, or drop the SD card.
Electrical noise, static electricity or the failure of this unit or the SD card may damage or erase the
data stored on the SD card.
When the card access lamp is lit, do not:
jRemove the SD card
jTurn the unit off
jInsert and remove the USB cable
jExpose the unit to vibrations or shock
Performing the above while the lamp is on may result in damage to data/SD card or this unit.
Inserting/removing an SD card
When using an SD card not from Panasonic, or one previously used on other equipment, for the first
time on this unit, format the SD card. (l 91) When the SD card is formatted, all of the recorded data
is deleted. Once the data is deleted, it cannot be restored. Copy valuable data onto a PC, DVD disc
etc. before proceeding with the formatting. (l 100, 112)
OPEN
Access lamp [ACCESS] A
When this unit is accessing the SD card or
built-in memory, the access lamp lights up.