Filter
Top Products
34
5. Using the supplied 75-ohm antenna cable,
connect the RF converter’s
OUT TO TV
jack
to the TV’s VHF antenna terminal.
• If the TV’s VHF antenna terminal is the
round, 75-ohm type, connect the cable
directly to the terminal.
• If the TV’s VHF antenna terminal is the
flat, 300-ohm type, use another matching
transformer (such as Cat. No. 15-1253,
not supplied) to connect the cable to the
terminal.
6. Set
CHANNEL
on the RF converter to
3
or
4
.
PLAYBACK
After you connect the camcorder to your TV, fol-
low these steps to play a tape.
1. Turn on the TV, then:
• If you are using a TV with audio/video
(A/V) jacks, set it to the video mode.
• If you are using a standard TV, set the
TV’s tuner to the same channel where
you set
CHANNEL
on the RF converter (
3
or
4
).
2. Slide
POWER
on the camcorder to
VCR
.
3. Insert a cassette into the camcorder.
4. Press
PLAY
on the camcorder. The tape
plays on your TV.
5. Press
STOP/EJECT
to stop playback. Press
STOP/EJECT
again to remove the cassette.
CHANNEL
16-830.fm Page 34 Wednesday, July 21, 1999 9:32 AM