Filter
Top Products
8
QUICK START
To eliminate complicated adjustments in most
situations, this camcorder has fully automatic
features for focus, white balance, and shutter
speed. All you need to do is press
REC/PAUSE
.
The following steps outline the basic procedures
for making a recording. In many of the steps,
you are directed to a specific section of this
manual that contains more detailed information.
When operating the camcorder for the first time,
read all the steps and the suggested detailed in-
formation before you actually begin.
1. Choose and connect a power source. See
“Selecting a Power Source” on Page 10.
2. Press
STOP/EJECT
to open the cassette
compartment. Insert a standard VHS cas-
sette, and close the compartment. See
“Inserting/Removing a Video Cassette” on
Page 16.
3. Slide
POWER
to
CAMERA
. The POWER
indicator lights. See “Setting the Power
Switch on Page 17.
Note:
If there is no cassette in the cam-
corder,
NO TAPE
appears in the view-
finder. If the cassette has its erase-
protection tab broken off,
TAPE
appears in
the viewfinder. See “Erase Protection” on
Page 39.
4. Adjust the viewfinder’s position until you
can look into it comfortably when the back
of the camcorder rests on your right shoul-
der. Then adjust the focus control on the
eyepiece for the sharpest picture in the
viewfinder. See “Preparing/Adjusting the
Viewfinder” on Page 14.
5. Place your right hand between the hand
strap and the camcorder. Then adjust the
hand strap so it fits tightly over your hand.
Note:
If the strap is too loose, the cam-
corder is difficult to handle.
6. Remove the lens cap and hang it on the
hand strap clip.
7. Point the camcorder at the desired subject,
then press
W
or
T
on the power zoom con-
trol until you see the desired picture in the
viewfinder. See “Variable Speed Power
Zoom” on Page 21.
8. To begin recording, press
REC/PAUSE
with
your right middle finger. During recording,
REC
appears in the viewfinder with arrows
above it to show the direction of tape travel.
Note:
When about 5 minutes or less
remain on the tape,
TAPE END
flashes in
the viewfinder.
9. To pause the tape, press
REC/PAUSE
again. The tape pauses, the arrows disap-
pear, and appears in the viewfinder.
To continue recording, press
REC/PAUSE
again.
16-830.fm Page 8 Wednesday, July 21, 1999 9:32 AM