Filter
Top Products
27
Recording
Install Cell
1. Make sure camcorder is turned off, and
remove any power supply attached to
the camcorder.
2. Pull our the clock cell holder.
3. Insert the clock cell with the “+”
terminal facing up in the cell holder.
4. Replace the clock cell holder. It will
click into place.
Install the Clock Lithium Cell
Remove Cell
To remove cell, slide the cell out of the
cell holder.
The clock cell indicator 88:88 will flash for a few seconds in the viewfinder when you
turn on the camcorder if the cell has not been installed or needs to be replaced.
Cautions: Lithium cell. Replace only with 3-volt lithium cell – such as CR2025.
Use of other cell presents a risk of fire or explosion. Must be disposed of properly.
Never handle punctured or leaking cell. May cause burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If
swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if
mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the + and – sides
of the cell.
Clock Cell
Holder