Filter
Top Products
060
SETUP
2(
2(
)
)
Auto power off
Auto power off
This function switches the camera off after a set amount of time in order
to prevent unnecessary battery drainage.
– Sub menus
[1, 3, 5, 10 min]
: The power will turn off
automatically if not used
for the period of time
specifi ed.
– After replacing the battery, the power off
setting will be preserved.
– Note that the automatic power off
function will not operate if the camera is
in the PC/Printer mode, slide show, playing back a voice recording and
playing back a movie clip.
LCD save
If you set the [LCD save] to On and the camera isn’t operated during
the specifi ed time, the LCD monitor will be turned off automatically.
– Sub menus
[Off]: The LCD monitor will not be
turned off.
[On]: If the camera isn’t operated
during the specifi ed time (about
30 SEC.), the camera power
will be idle (Camera status
lamp:Blinking) automatically.
Selecting video out type
Selecting video out type
The Movie output signal from the camera can be NTSC or PAL. Your
choice of output will be governed by the type of device (monitor or TV,
etc.) to which the camera is connected. PAL mode can support only
BDGHI.
Connecting to an external monitor
When the camera is connected to an
external monitor, the image and menus
on the LCD monitor will be visible on the
external monitor and the LCD monitor of
the camera.
Selecting Video
out type
Description
NTSC
U.S.A, Canada, Japan, South Korea, Taiwan,
Mexico.
PAL
Australia, Austria, Belgium, China, Denmark,
Finland, Germany, U.K., Holland, Italy, Kuwait,
Malaysia, New Zealand, Singapore, Spain,
Sweden, Switzerland, Thailand, Norway.