Filter
Top Products
BRACKET-
HDD(A)
BRACKET-
HDD(B)
BRACKET-HDD(A)
SCREW-SPECIAL
Screwdriver
Screwdriver
10_ installation
3. There are brackets (Bracket-HDD) mounted
on the right and left sides where you can
mount HDDs. Remove the screws holding
each bracket to mount an HDD onto.
4. If you want to add a hard disk, remove
Bracket-HDD(A), power supply cable, signal
transmission cable (IDE Cable), and fan
cable.
5. To add a hard disk, the built-in HDD (Primary
Master) should have been installed. Basically
a built-in HDD has been installed as the
Primary Master and a DVD-RW driver as the
Secondary Master. Before adding a hard
disk, set the jumper for master and slave.
The jumper setting method is illustrated
on the surface of the purchased hard disk.
Fix the hard disk to the Bracket using the
(A)SCREW-SPECIAL (BWH, 6-32UNC, L10.
5). Align the 5 spots on the bottom and
mounting holes of the Bracket, insert the
HDD, and then fix it using the screws.
SHR-5162_Eng.indb 10 2007-06-18 ｿﾀﾀ・11:47:50