Filter
Top Products
18_ live
Audio On/Off setting in 4, 6, 7, 8,
and 9-split modes and PIP mode
As in 16-split mode, when pressing the ENTER
button in 4, 6, 7, 8, and 9-split modes and PIP
mode, the selection cursor appears for you to
select a channel.
After selecting a channel, you can set the Audio
to On or Off using the AUDIO button. According
to the audio On/Off setting condition, the Audio
icon of the selected channel changes to yellow
and white.
FREEZING AND ZOOMING
Freeze function
The freeze function pauses the video image on
the live screen and it is only available in the live
mode.
You can set this function to On or Off using the
FREEZE button on the front panel or remote
control.
Zoom function
The zoom function enlarges the selected area to
double size, and it is only available in the single
screen mode.
When you press the ZOOM button on the
front panel or remote control, the zooming area
appears. Use the UP/DOWN/LEFT/RIGHT
direction buttons to adjust the position for
zooming. After selecting the Zoom area, press
the ENTER button to enlarge the selected area
in double size. To cancel the zooming function,
press the ZOOM button again.
EVENT MONITORING
The event monitoring is used to display the
channel that is synchronized with an event on
the screen when a special event (Sensor/Motion/
Video Loss) occurs. The settings for event
monitoring activation and event duration setup
are done in the Monitoring on the menu.
If you set the event monitoring interval to 5
seconds and an event occurs at CH 2 as shown
in the picture, the system will display CH 2 in full
screen for 5 seconds. If another event occurs
within 5 seconds, it is also displayed together
with the existing event.
As shown in the picture, if we assume that both
CH 1 and CH 3 events occur within 5 seconds
(for example, after 4 seconds), after CH 2 event,
these three events are displayed with split into 4
screens.
If a new event does not occur during the event
duration, the system will return to the previous
live mode. Pressing the ALARM button during
the event duration makes the event monitoring
stop. When an event occurs, the ALARM LED
is turned on. Press the ALARM button again
to turn ALARM LED Off. At this time, the alarm
s
etup is initialized, the event icon disappears, and
the event monitoring is cancelled while in event
monitoring. After alarming, the event recording
resumes.
[ Event-driven screen changes in Event Monitoring ]
SHR-5162_Eng.indb 18 2007-06-18 ｿﾀﾀ・11:48:05