Sanyo SID-70 Security Camera User Manual


  Open as PDF
of 19
 
COLOR DOME CAMERA User Guide
10
COLOR DOME CAMERA User Guide
11
Anarrowforinstalling
directions
1) Separate the dome cover by turning anti-clockwise.
2) Separate the shield case by pulling from the camera body.
* To install the dome cover on the camera
body, turn the latches in locking direction
as shown in the figure 1.
Latch
Lockingdirection
[Figure1]
Lockingdirection
(Clockwise)
MainBody
(Camera)
ShieldCase
Domecover
Unlocking direction
(Anti-clockwise)
Installation
When using the Ceiling bracket
Installation
•Theinstallationshouldbedonebyqualified
service personnel or system installers.
•Iftheceilingmaterialisnotstrongenoughto
hold the installation screws, the camera may
falloff.Reinforcetheceilingasneeded.
•Tochangethepositionofthecable,take
awaytheHoleCoverandpassthecable
through.
Notes
Originalpositionof
the cable
HoleCover
[Figure-2]
M4tapping
screw
PanBase
fixation
screw
Unlocking
direction
M4tapping
screw (provided)
Domecover
CAMERA
Locking
direction
Ceilingbracket
1) Hold the ceiling bracket (located where the arrow
points to) and separate it from the main body of
the camera by rotating it anti-clockwise.
(refer to the picture in 'Notes' on page 10)
2) Place the separated ceiling bracket so that the
“Front” side faces the area to be monitored and
install it with the M4 tapping screws.
3) To combine the main body with the ceiling bracket,
make sure that the pan base fixation screw face the
opposite side of the “Front” side of the ceiling
bracket and rotate it clockwise.
4) Adjust the camera lens to face the area to be
monitored and fix the main body and the dome
cover by aligning the grooves and rotating the
body clockwise.
•
Ifyouwanttoinstallthecamerawiththeceilingbracketcombined,fixitusingtwoM4tapping
screwsatthesideofthemainbody(refertothe[Figure-2]onpage11).
Notes
 previous next