Sanyo SID-70 Security Camera User Manual


  Open as PDF
of 19
 
COLOR DOME CAMERA User Guide
12
COLOR DOME CAMERA User Guide
13
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
•PanBasemovesby176˚toeachsidedirectionand352˚onthewhole.
•TiltBasecoverstotal73˚angle(0˚~73˚).
•RotateBasemovesby174°toeachsidedirectionand348°onthewhole.
2) Methods of adjustment
•The case of wall installation
1
After mounting the camera on a wall, adjusting the panning angle so that the camera can
face the direction to monitor when tilted.
2
Adjust the tilting angle by rotating the tilt base.
3
Loosen the rotate base hold screw and adjust rotate base for the best view.
4
Tighten the rotate base hold screw.
•The case of ceiling installation
1
After mounting the camera on a ceiling, adjusting the panning angle to the correct viewing
position by rotating the pan base.
2
Adjust the tilting angle by rotating the tilt base.
3
Loosen the rotate base hold screw and adjust rotate base for the best view.
4
Tighten the rotate base hold screw.
Adjust the panning and tilting, rotating while watching the monitor
Installation
Connect the Video Output jack to the VIDEO-IN jack of monitor.
CCTVCamera Monitor
• As the connecting method varies with the instruments, refer to the manual supplied with the
instrument.
• If necessary, you can connect the monitor to the REMOTE jack on the back of your camera.
• Only connect the cable when the power is turned off.
Connect the adaptor to the power input terminal as shown in the figure below. The
recommended adaptor specification for SID-70N/SID-70P is DC 12V / 500mA or AC 24V /
300mA.
Connection
Connecting to Monitor
Connecting to Power
73˚
176˚
174˚ 174˚
176˚
Pan Base
Tilt Base
Rotate Base
----PowerInputTerminal
• As shown in the table above, voltage decreases as the wire gets longer. Therefore
use of an excessively long adaptor output line for connection to the camera may
affect the performance of the camera.
*Standard voltage for camera operation : DC 12V ± 10%, AC 24V ±10%
*
There may be some deviation in voltage drop depending on the type of wire and the manufacturer.
When the resistance value of copper wire is at [20˚C(68˚F)]
Copper wire size (AWG)
#24(0.22mm
2
) #22(0.33mm
2
) #20(0.52mm
2
) #18(0.83mm
2
)
Resistance (Ω/m)
0.078 0.050 0.030 0.018
Voltage Drop (V/m)
0.028 0.018 0.011 0.006
 previous next