Filter
Top Products
63
E
E
12. Do not allow any water droplets to get
inside housing. This will cause the
inside of the housing to fog.
13. Close housing lid tightly. Make sure
there are no obstructions that prevent
the housing from closing. Make sure lid
is tightly pressed into housing, ( see
picture).
14. Close housing latch. Make sure the lid
is pressed flat and evenly against the
housing body. The housing may leak if
the lid is not flat against the housing
when closed.
Test camera and housing
1. Press the external power button on the top of the housing to turn camera
power on.
2. Press the shutter button on the outside of the housing to take a test picture.
3. The power or shutter button should have a smooth action and return to its
original resting position after pressing. It is normal to feel some resistance
when pressing the power and shutter button.
4. Press and hold power button to turn camera power off. It is recommended
to leave camera power off until you’re ready to use camera to preserve
battery power.
5. After 3 minutes the LCD and monitor will turn off, and the camera will in power
save mode. To re-activate power, push the SHUTTER BUTTON.
6. After 15 minutes the camera power will shut down. To operate the camera,
push the POWER BUTTON to turn on the camera.
Close housing lid tightly, then close
latch.