Filter
Top Products
15
Preparation
Preparation
Adjusting the Hand Strap
1 Open the hand strap flap (1) and the
grip strap (2).
2 Loosen the grip strap, pass your right
hand through the loop, and put your
thumb on the REC START/STOP button.
Then, pull the grip strap tight until it fits
snugly.
3 Seal the velcro fasteners of the grip
strap and the hand strap flap.
Caution:
• Do not swing the camcorder by the hand strap.
When attaching or
removing the lens cap,
press both tabs on the
top and bottom of the
cap.
When recording, hang
the hook of the lens cap
on the hand strap so that
the cap will not get in the
way.
5
6
7
4
3
2
Tabs
2 Hold one end of the strap and thread it
through the loop on the left side of the
power source mounting surface.
3 Loosen the strap in the buckle, then feed
the end of the strap through the buckle,
as shown.
4 Draw the strap in the direction of the
arrow to secure.
5–7 To attach the other end of the strap to
the loop on the left side of the hand
strap, open the hand strap flap,
perform the same procedure, and then
attach the battery pack.
Loop
Loop
Buckle
Hook
REC START/STOP button
Note:
• Always replace the lens
cap on the lens when the
camcorder is not in use.
Attaching the Shoulder Strap
1 Remove the battery pack.
Using the Lens Cap
Attach the strap of the lens cap to the hand
strap as shown below.
Buckle