Filter
Top Products
Chapter 4 Viewfinder Screen Indications and Menus 77
Chapter 4 Viewfinder Screen Indications and Menus
@™ Voltage/error indication
The current voltage is displayed whenever the power
supply voltage dips below 11.3 V DC. However, you
can also display the current voltage at any time by
pressing and holding the MENU switch in the upward
position (the display is shown for as long as you hold
the switch upward).
An error message is displayed when an abnormality
has been detected by the auto diagnostic function
(page 82). If there is a voltage drop below 11.3 V DC
and an error has been detected, the low voltage
indication alternates at one-second intervals with the
error indication.
If an error message appears, contact your Sony dealer.
If using an Anton Bauer Intelligent Battery System
The remaining battery capacity is shown as a
percentage.
@£ Shutter setting indication
When the SHUTTER switch has been set to ON, the
shutter speed or CLS frequency set in basic menu page
1 is displayed here.
Status Indications
If you set the MENU switch to STATUS while a menu
is being displayed, the camcorder’s current setting
status will be shown in this display area.
T : A 3200K
RS:STD
RX:STD
+:OFF
E
I
I
I
I
T
C
H
.
A
C
W
A
M
D
OFF:SS
BATT: 13.0V
a) When both the DCC+ and DynaLatitude
functions are set to OFF
Display
Description
WHITE White balance adjustment method
selection (PRE/A/B) and color
temperature during auto white
balance adjustment
A.IRIS
MATRIX Setting of the MATRIX switch (page
21)
DCC+ or DL
Iris adjustment method selection
(STD/SPOT L/BACK L)
For DCC+ indication: ON with the
OUTPUT/DL/DCC+ switch set to
CAM/DCC+ (DCC+ ON), and OFF
with the switch set to CAM/DL and DL
in advanced menu page 2 (page 85)
set to OFF (both DCC+ and
DynaLatitude OFF).
For DL indication: When setting the
OUTPUT/DL/DCC+ switch to DL and
DL in advanced menu page 2 to OFF
(DynaLatitude OFF), LOW, STD or
HIGH is displayed according to DL
LEV setting in basic menu page 2
(page 79).
a)