Filter
Top Products
Chapter 4 Viewfinder Screen Indications and Menus 81
Chapter 4 Viewfinder Screen Indications and Menus
Initial cursor position
(Space)
5 Repeat steps 2 to 4 until the title is complete.
EXIT(YESmPUSH)
DSR-300
6 Align the cursor to EXIT and press the MENU
dial.
This displays basic menu page 6 again.
The title created is retained, even when you power
the camcorder off.
To record a title (page 7)
1 Access basic menu page 7 (title display).
mTITLE IND(YESmPUSH)
2 Press the MENU dial once.
The title is superimposed to the picture displayed
on the viewfinder screen.
3 Start shooting.
4 To stop the title recording, press the MENU switch
or MENU dial to clear the title display.
Entering the title (page 6)
1 Press the MENU switch or turn the MENU dial as
necessary to display basic menu page 6 (title
setting display) in the viewfinder.
mTITLE SET(YESmPUSH)
If a title is already present, it appears on this
screen.
2 Press and turn the MENU dial until the desired
character appears, and press it.
The character cycles through the following
sequence.
ABCDEFGHIJKLMNOPQRSTUVWXYZ0123456789?;x/: -
.,
Press the MENU dial when the desired character
appears.
3 Press the MENU dial.
This brings up the cursor on the screen, and
switches to cursor transport mode.
EXIT(YESmPUSH)
4 Turn the MENU dial to move the cursor to the
position where you wish to insert a character.
To reverse the cursor, turn the dial in the opposite
direction.