Filter
Top Products
93
Editing
You can record additional audio to the original sound on the tape by connecting audio
equipment or a microphone. If you connect the audio equipment, you can add sound to
your tape already recorded in the 12-bit mode by specifying start and end points. The
original sound will not be erased.
You cannot dub audio in the following cases:
•The tape recorded in the 16-bit mode
•The tape recorded in the LP mode
•Connecting with the DV Interface
•The blank portions of the tape
•When the write-protect tab of the cassette is set to lock.
Preparing for audio dubbing
You can record additional audio in the following:
• Dubbing with the built-in microphone
• Connecting the microphone (optional) to the MIC jack
• Connecting the microphone (optional) to the intelligent accessory shoe
• Connecting the A/V connecting cable to the AUDIO/VIDEO jack
The audio input to be recorded takes precedence over others in the following order:
•MIC jack
•Intelligent accessory shoe
•AUDIO/VIDEO jack
•Built-in microphone
Dubbing with the built-in microphone
No connection is necessary.
Connecting the microphone (optional) to the MIC jack
You can check the recorded picture and sound by connecting the AUDIO/VIDEO jack
to a TV.
The recorded sound is not output from a speaker. Check the sound by using the
headphones or a TV.
Audio dubbing
MIC (PLUG IN
POWER) jack
: Signal flow
Microphone (optional)