Filter
Top Products
249
Troubleshooting Поиск и устранение неисправностей
Others
Symptom Cause and/or Corrective Actions
• 20 titles have been recorded.
c Erase unnecessary title (p. 119).
• The cassette is set to prevent accidental erasure.
c Slide the write-protect tab so that red portion is not visible
(p. 35).
• The tape has a blank portion in the recorded portion.
c Superimpose the title to the recorded position (p. 117).
• The tape is set to prevent accidental erasure.
c Slide the write-protect tab so that red portion is not visible
(p. 35).
• COMMANDER is set to OFF in the menu settings.
c Set it to ON (p. 235).
• Something is blocking the infrared rays.
c Remove the obstacle.
• The batteries are inserted in the battery holder with the + –
polarities incorrectly matching the + – marks.
c Insert the batteries with the correct polarity (p. 291).
• The batteries are dead.
c Insert new ones (p. 291).
• DISPLAY is set to V-OUT/LCD in the menu settings.
c Set it to LCD (p. 235).
• VIDEOINPUT is not set correctly in the menu settings.
c Set it to the appropriate setting (p. 230).
• VIDEOINPUT is not set correctly in the menu settings.
c Set it to the appropriate setting.
• Moisture condensation has occurred.
c Remove the cassette and leave your camcorder for at least
one hour to acclimatise (p. 271).
• Some troubles have occurred in your camcorder.
c Remove the cassette and insert it again, then operate your
camcorder.
• Disconnect the AC power adaptor from a wall socket or take
out the battery, then reconnect it in about one minute. Turn the
power on. If the functions still do not work, press RESET using
a sharp-pointed object. (If you press RESET, all the settings
(DCR-IP220E: except the NETWORK mode settings) including
the date and time return to the default) (p. 285).
(continued on the following page)
Types of trouble and how to correct trouble
A title is not recorded.
A cassette label is not recorded.
The Remote Commander supplied
with your camcorder does not work.
The picture from a TV or VCR does
not appear even when your
camcorder is connected to the
outputs on the TV or VCR.
Dubbing cannot be made when using
the A/V connecting cable.
The melody or beep sounds for
five seconds.
No function works though the power
is on.