Filter
Top Products
9
Getting started
Notes on charging the battery pack
• The CHARGE lamp will remain lit for a while even if the battery pack is removed
and the power cord is unplugged after charging the battery pack. This is normal.
• If the CHARGE lamp does not light, disconnect the power cord. After about one
minute, reconnect the power cord again.
• You cannot charge the battery pack while the DK-415 connecting cord is connected
to the AC power adaptor.
• When a fully charged battery pack is installed, the CHARGE lamp will light once,
then go out.
Installing the battery pack
(1)Set the POWER switch to OFF to prevent misoperation of the camcorder.
(2)To open the lid of the battery compartment, slide the OPEN (BATT) release lever.
(3)Insert the battery pack in the direction of the arrow.
(4)Close the lid.
To remove the battery pack
Open the lid of the battery compartment. Then release the battery release lever, and
remove the battery pack.
When removing battery pack
Always keep the lid of the battery compartment upright so that the battery pack does
not fall out when you open the lid.
Charging and installing the battery pack
Battery release lever
123
4
VTR
CAMERA
OFF
POWER