Filter
Top Products
Playback menu
121
You can protect images against accidental erasure.
Using the camera, you can specify the images and the number of images to
print before you print images at a shop or with your printer.
DPOF specifications are left with images after printing.
Notes
• You cannot specify DPOF on RAW images.
• You can specify any number up to 9.
Protect
Marked images Protects selected images or cancels the protection of the
selected images.
1Select the image you want to protect with b/B on the
multi-selector, then press the center of the multi-selector.
(To cancel a selection, press the center again.)
To protect other images or cancel the protection of other
images, repeat this step.
2Press the MENU button. After a message appears, select
[OK] with v on the multi-selector, then press the center of
the multi-selector.
All images Protects all the images or cancels the protection of all the
images in the memory card. After a message appears, select
[OK] with v on the multi-selector, then press the center of
the multi-selector.
Cancel all
DPOF setup
Marked images Specifies/unspecifies DPOF on the selected images.
1Select the image you want to specify DPOF with b/B on
the multi-selector, then select the number of sheets with
the rear control dial. (To unspecify DPOF, set the number
to “0.”)
To specify/unspecify DPOF on other images, repeat this
step.
2Press the MENU button. After a message appears, select
[OK] with v on the multi-selector, then press the center of
the multi-selector.
All images To specify/unspecify DPOF on all the images in the memory
card. When [All images] is selected, set the number of
images with v/V on the multi-selector, then press the center
of the multi-selector. After a message appears, select [OK]
with v on the multi-selector, then press the center of the
multi-selector.
Cancel all