Filter
Top Products
162
• Disconnect and connect the USB cable again. If an error message is
indicated on the printer, refer to the operating instructions supplied with the
printer.
Cannot print images.
• RAW images cannot be printed.
• Images shot using cameras other than this camera or images modified with
a computer may not be printed.
“---- -- --” is printed on the date-inserted part of the image.
• Images that do not have the recording data cannot be printed with the date
inserted. Set [Date imprint] to [Off] and print the image again (page 153).
The message “Set date and time?” appears when you turn on the camera.
• The camera has been left unused for sometime with a low battery or no
battery pack. Charge the battery pack and set the date again (page 27). If the
date setting is lost every time the battery pack is charged, consult your Sony
dealer or local authorized Sony service facility.
The number of recordable images does not decrease or decreases two at
a time.
• This is because the compression rate and the image size after compression
change depending on the image when you shoot a JPEG image (page 105).
The setting is reset without the resetting operation.
• The battery pack was removed when the power switch was set to ON. When
removing the battery pack, make sure the camera is turned off and the
access lamp is not illuminated (page 18).
The camera does not work properly.
• Turn off the camera. Remove the battery pack and insert it again. If an AC
Adaptor/charger (sold separately) is used, disconnect the power cord. If the
camera is hot, allow it to cool down before trying this corrective procedure.
If the camera does not work after doing these solutions, consult your Sony
dealer or local authorized Sony service facility.
Others