Filter
Top Products
61
Setting the Electronic Shutter
Chapter 4 Adjustments and Settings for Recording
Setting the shutter speed in ECS mode
Proceed as follows:
1
Set the shutter speed mode to ECS.
Example of view finder screen display
for ECS setting operation
2
Turn the MENU knob counterclockwise as seen from
the front of the camera to increase the value, or
clockwise to decrease the value, until the desired
frequency appears.
The frequency range can be changed between 60.1 and
7000 Hz (DVW-970) or between 50.2 and 9000 Hz
(DVW-970P).
When the RM-B150/B750 Remote Control Unit is
connected
You can set the shutter speed of ECS with the rotary
encoder of the RM-B150/B750.
Setting the shutter speed in SLS mode
Proceed as follows:
1
Set the shutter speed mode to SLS.
Example of view finder screen display
for SLS setting operation
2
Turn the MENU knob until the desired number of
frames appears.
The number of frames can be set to values in the range
1 to 8, and 16 (1 frame nearly equals to 1/30 second
(DVW-970) or 1/25 second (DVW-970P)).
Changing the range of choice of shutter
mode and speed settings
You can reduce the time required to select the shutter mode
and speed by narrowing the choice of settings in advance.
This can be done by using the SHT ENABLE page of the
OPERATION menu.
Proceed as follows:
The settings selected on the SHT ENABLE page of the
OPERATION menu become invalid when the RM-B150/
B750 Remote Control Unit is connected to the camcorder.
1
Set the MENU ON/OFF switch to ON while holding
down the MENU knob.
The TOP menu appears.
2
Turn the MENU knob to move the b mark to
OPERATION.
12
ECS:60.00Hz
12
Note
SLS: 1/30 : 1FRAME
MENU knob
MENU ON/OFF switch