Filter
Top Products
13
Basic Functions
Initial Settings and Position Preset
The initial values are those set at the factory. Settings
for items in Position presets 1 to 6 that will be retained
even when the power to the camera is turned off are
indicated by a “O,” those that will be lost are indicated
by an “X.”
•When the power is turned on, the settings retained in
POSITION 1 will be called up as the initial settings.
•When a CAM_Memory Reset command is sent, or a
choice is made from POSITION 1 to 6 while the
RESET button on the Remote Commander is being
pressed, the settings selected will be used as the
initial settings.
• Position preset 1 becomes VISCA command
CAM_Memory memory number 0. Position presets 2
through 6 become VISCA command CAM_Memory
memory numbers 1 through 5.
Category Mode/Position Initial settings Position Position
preset 1
presets 2 to 6
Pan/Tilt Pan/Tilt Position Home position aa
Pan/Tilt Limit Position movable-range maximum a ×
Zoom Zoom Position Wide end aa
D-Zoom Limit x4 aa
Focus Position — aa
Focus Focus Auto/Manual Auto aa
Near Limit Setting 7600h (10 cm) a ×
WB Mode Auto aa
WB WB Data (Rgain, Bgain) — aa
One Push WB Data — a ×
AE Mode Full Auto aa
AutoSlowShutterLimite 1/60sec (59.94/29.97/NTSC), 1/50sec (50/25/PAL) aa
Shutter Position 1/60sec (59.94/29.97/NTSC), 1/50sec (50/25/PAL) aa
Iris Position — aa
AE Gain Position — aa
Bright Position — aa
Exposure Compensation On/Off Off aa
Exposure Compensation Amount ±0 aa
Backlight On/Off Off aa
Apperture Aperture Level 8 aa
IR IR_Receive On/Off On a ×
IR_ReceiveReturn On/Off Off a ×
OSD Display Information On/Off On a ×
Effect Picture Effect Off a ×
System D-SUB 15Pin SYNC 3-STATE a ×
Memroy Preset Memory Same as the initial value setting aa
Notes
• The number of times data can be written to the EEPROM (by executing Position Preset) is limited.
• If you want the camera status and Pan/Tilt positions in effect before the camera is turned off to be retained when the power is
turned OFF, then turned ON again, have the camera memorize those positions in POSITION 1.
• It takes approximately 2 seconds longer to memorize or erase settings in POSITION 1 than it does to memorize or erase
settings in any other channel.
• Camera ID data will be saved regardless of the position preset.