Filter
Top Products
15
Basic Functions
White Balance
Mode Power On
Power Off
1)
IFC
2)
Initializing
3)
White balance mode
During displaying
Memory Recall
Command Auto Indoor Outdoor One Push Manual the menu
CAM_WB Auto/Indoor/Outdoor/
OnePhshWB/Manual
×××aaaaa ×
4)
×
CAM_WB One Push Trigger ××××××a
5)
××
4)
×
CAM_WB R(B) Gain
Reset/Up/Down/Direct
×××××××a ×
4)
×
1) DC power is being supplied, but the camera has been turned off by a VISCA command.
2) The period from the time IF Clear is sent, until the Reply Packet is returned.
3) The period from the time DC power is turned on or the camera is turned on via a VISCA command, and the camera subsequently fi
nishes the pan/tilt reset operation and stops at the Home position, until the
video signal is output. Or the period from the time the CAM Power ON command is sent, until Completion is returned.
4) The camera is not limited in operation due to the menus. But the camera follows the operational restrictions of the current m
ode during IFC executing/initializing/white balance mode operation.
5) Commands are ignored during a One Push AWB operation.
Zoom/Focus
Mode Power On
Power Off
1)
IFC
2)
Initializing
3)
Zoom Direct Focus Direct AF ON
During displaying
Memory Recall
Command the menu
CAM_Zoom Tele/Wide/Stop [VISCA] ××××aa×
4)
×
CAM_Zoom Tele/Wide/Stop [RC] ××××aa×
4)
×
CAM_Zoom Direct ×××aaa×
4)
×
D-Zoom Limit ××××aa×
4)
×
CAM_Focus Far/Near/Stop [VISCA] ×××a ×××
4)
×
CAM_Focus Far/Near/Stop [RC] ×××a ×××
4)
×
CAM_Focus Direct ×××aa××
4)
×
CAM_Focus Mode (Auto/Manual) ×××a × a ×
4)
×
CAM_Focus One Push Trigger ×××a ×××
4)
×
CAM_Focus Infinity ×××a × a ×
4)
×
CAM_Focus Near Limit ×××a × a ×
4)
×
1) DC power is being supplied, but the camera has been turned off by a VISCA command.
2) The period from the time IF Clear is sent, until the Reply Packet is returned.
3) The period from the time DC power is turned on or the camera is turned on via a VISCA command, and the camera subsequently fi
nishes the pan/tilt reset operation and stops at the Home position, until the
video signal is output. Or the period from the time the CAM Power ON command is sent, until Completion is returned.
4) The camera is not limited in operation due to the menus. But the camera follows the operational restrictions of the current m
ode while the camera is receiving the command in each mode.