92
Troubleshooting
Warning indicators and messages
If indicators appear in the viewfinder
(HDR-SR7E/SR8E) or on the LCD screen,
check the following.
You can fix some symptoms by yourself. If
the problem persists even after you have tried
a couple of times, contact your Sony dealer
or local authorized Sony service facility.
C:(or E:) ss:ss (Self-diagnosis
display)
C:04:ss
• The battery pack is not an
“InfoLITHIUM” battery pack (H
series). Use an “InfoLITHIUM” battery
pack (H series) (p.101).
• Connect the DC plug of the AC
Adaptor to the DC IN jack of the
Handycam Station or your camcorder
securely (p.16).
C:13:ss / C:32:ss
• Remove the power source. Reconnect it
and operate your camcorder again.
E:20:ss / E:31:ss / E:61:ss /
E:62:ss / E:91:ss / E:94:ss
• A malfunction that you cannot service
has occurred. Contact your Sony dealer
or local authorized Sony service
facility. Inform them of the 5-digit
code, which starts from “E”.
101-0001 (Warning indicator
pertaining to files)
Slow flashing
• The file is damaged.
• The file is unreadable.
(Warning on the hard disk of the
camcorder)*
Fast flashing
• An error may have occurred with the
hard disk drive in your camcorder.
(Warning on the hard disk of the
camcorder)*
Fast flashing
• The hard disk of the camcorder is fully
recorded.
• An error may have occurred with the
hard disk drive in your camcorder.
E (Battery level warning)
Slow flashing
• The battery pack is nearly used up.
• Depending on the operating
environment or battery conditions, E
may flash, even if there are
approximately 20 minutes remaining.
(High temperature warning)
Slow flashing
• The temperature of your camcorder is
getting higher. Turn off your camcorder
and leave it for a while in a cool place.
Fast flashing*
• The temperature of your camcorder is
extremely high. Turn off your
camcorder and leave it for a while in a
cool place.
(Low temperature warning)*
Fast flashing
• The temperature of your camcorder is
extremely low. Make the camcorder
warm.
Self-diagnosis display/Warning
indicators
C:04:00