Filter
Top Products
Playing Back Clips
82
Playback
For playback operations, use the following
playback control buttons.
• When the IR Remote Commander is enabled,
you can use its playback control buttons instead
(see page 30).
• Use the jog dial when you move the cursor on
the thumbnail screen or proceed to the next step
of operations.
1 Operating the jog dial, move the cursor
to the thumbnail image of the clip with
which you wish to start playback.
2 Press the PLAY/PAUSE button.
Playback starts from the beginning of the
selected clip.
The clips after the selected clips are played back
in sequence.
When playback of the last clip ends, the
camcorder enters PAUSE (still picture) mode at
the last frame of the last clip.
Press the THUMBNAIL button to return to the
thumbnail screen.
Notes
• The playback picture may be momentarily
distorted or frozen between clips. The playback
control buttons and THUMBNAIL button do
not function during this condition.
• When you select a clip on the thumbnail screen
and start playback, the playback picture at the
beginning of the clip may be distorted. To start
playback without distortion, once pause
playback after starting it, press the PREV button
to return to the top of the clip, then restart
playback.
Information displayed on the playback
screen
The following information is superimposed on
the playback picture.
1.Battery remaining/DC IN voltage
2.Playback mode
3.SxS memory card in use
A mark appears if the memory card is write-
protected.
4.Time data
The time data for the playback picture are
displayed. Each time you press the TC/U-BIT/
DURATION button, the indication is switched
between timecode (TCR) and user-bit (UB)
data.
Playing Back Clips
Playing Back the Selected and
Subsequent Clips in Sequence
PLAY/PAUSE
F FWD
THUMBNAIL
BARS/CAM F REV
PREV STOP NEXT
lsL
j
G
/SJ
PLAY/PAUSE button
F REV button
PREV button
STOP button
F FWD button
NEXT butto
n
TCR 00:00:00:00
0011/03 00
120min B PLAY
CH1
CH2
1234
5
6