Sony SNC-CS20 Security Camera User Manual


 
Administrating the Camera
Setting the Camera Image and Audio — Camera Menu
45
Unicast streaming
Specify the communication port numbers of the
MPEG4/H.264 video data and audio data to be used
when UDP (unicast) or UDP (multicast) is selected on
the welcome page.
Video port number
Specify the communication port number of the MPEG4
video data. It is initially set to 50000. Specify an even
number from 1024 to 65534. Two port numbers (the
number specified here and an odd number with 1 added
to the specified number) are actually used for video data
communication and control.
Audio port number
Specify the communication port number of the audio
data. It is initially set to 50002. Specify an even number
from 1024 to 65534. Two port numbers (the number
specified here and an odd number with 1 added to the
specified number) are actually used for audio data
communication and control.
Note
Specify different numbers for the video port number and
the audio port number.
Multicast streaming
Set whether the camera uses multicast streaming for
MPEG4 video data and audio data or not. It reduces the
transmission load on the camera by making the
computer of the same segment network receive the same
transmitting data.
Select On to allow and Off not to allow multicast
sending.
When you select On, set Multicast address, Video port
number and Audio port number properly.
Multicast address
Type the multicast address used on the Multicast
streaming.
Video port number
Specify the communication port number of the MPEG4
video data used for the Multicast streaming. It is initially
set to 60000. Specify an even number from 1024 to
65534. Two port numbers (the number specified here
and an odd number with 1 added to the specified
number) are actually used for video data communication
and control.
Audio port number
Specify the audio port number used for the Multicast
streaming. It is initially set to 60002. Specify an even
number from 1024 to 65534. Two port numbers (the
number specified here and an odd number with 1 added
to the specified number) are actually used for audio data
communication and control.
Note
Specify different numbers for the video port number and
the audio port number.
TTL
Specify the number of times multicast streaming packet
could pass the router.
OK/Cancel
See “Buttons common to every menu” on page 28.