Filter
Top Products
Administrating the Camera
Configuring the System — System Menu
29
Automatically adjust clock for daylight saving
time changes
When you select it, the clock is automatically adjusted
according to the daylight saving time of the selected
time zone.
Note
If the time zone selected in Time zone is different from
that set on the computer, the time is adjusted using the
time zone difference and set on the camera.
OK/Cancel
See “Buttons common to every menu” on page 26.
Initialize Tab
Reboot
Reboots the camera.
Click Reboot, and the message “The Camera will be
rebooted. Are you sure?” appears. Click OK to reboot
the camera. It takes about two minutes to start again.
Factory default
Resets the camera to the factory settings.
Click Factory default, and the message “Setup data will
be initialized. Are you sure?” appears. When you click
OK, the network indicator on the camera starts to blink.
After adjustments of the default settings have finished,
the camera reboots automatically. Do not turn off the
camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of this unit while pressing the reset
switch on the camera. For details, see the supplied
Installation Manual.
Backup setting data
Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the browser to
specify the folder and save the setting data of the
camera. The file name preset at the factory is “snc-
cs50.cfg.”
Restore setting
Loads the stored setting data of the camera.
Click Browse and select the file in which the setting data
is stored. Then, click OK, and the camera is adjusted
according to the loaded data and restarted.
Note
With Restore setting, some items in the Network menu
(page 36) cannot be restored.
Format ATA memory card
Click Format to format the ATA memory card (not
supplied) inserted into the PC card slot of the camera.
The files and folders stored in the ATA memory card are
deleted while formatting.
Notes
• Before formatting, disable the image memory
function and the FTP server function to protect the
ATA memory card against writing.
• Do not activate the Format ATA memory card
function when no card is inserted into the PC card slot.
Delete custom homepage
By pressing Delete, you can delete the homepage
recorded in the flash memory of the camera with
Custom Homepage Installer (page 71).
Delete voice alert file
Click Delete to delete the audio file stored in the camera
using SNC audio upload tool (page 66).
Note
Before deleting the audio file, set Voice alert to Off in
the Voice alert menu (page 52).