Filter
Top Products
Additional information
21
You cannot connect to the
desired device.
• The device is not turned on.
• The device is not connectable.
• The device ran past the time limit.
• The device is placed outside of radio wave
range.
• The antenna portion of your camera or the
device is covered with your hand etc.
• The desired device is now connecting to another
device.
• Passkey authentication failed.
• You did not enter the passkey on the device.
• The device you intend to connect to is different.
• The connection has been rejected.
• Since passkey authentication has failed
repeatedly, the connection may be rejected for a
while.
• The device is not BIP-compatible.
p Turn on the device. For details, refer to the operating
instructions supplied with the device.
p Check that the Bluetooth function of the device is started up and
the device is connectable.
p Set the device so that it is connectable and perform a new search
(page 7).
p Move the device closer to your camera.
p Do not cover the antenna portion (page 4).
p Wait until the connection is finished and perform a new search
(page 7).
p Connect again and enter the same passkey both on your camera
and the device (page 17).
p Whether the passkey entry screen first appears on your camera
or the device you intend to connect depends on the setting and
the device. Connect again and enter the same passkey (page 17).
p Check the name on the SELECT THE RECEIVER screen.
p Set the device so that it is connectable. For details, refer to the
operating instructions supplied with the device.
p Try to connect again after a while.
p The camera can connect to only a BIP-compatible device
(page 4).
You cannot select the
desired image.
• A movie or Clip Motion file has been selected.
• No images in the selected folder.
p Select an image other than Movie or Clip Motion file.
p Select the folder where the image is stored (see the operating
instructions).
Symptom Cause Solution