Filter
Top Products
Additional information
25
Remote camera
Symptom Cause Solution
The Bluetooth button
does not work.
• The MODE dial is not set to , P, or SCN.
• The camera is in quick review mode.
p Set the MODE dial to , P, or SCN (see the operating
instructions).
p Exit the quick review mode (see the operating instructions).
[REMOTE CAMERA] in the
Bluetooth menu cannot be
selected.
• The MODE dial is not set to , P, or SCN.
• No “Memory Stick” is inserted.
• The write-protect switch on the “Memory Stick”
is set to the LOCK position.
• The capacity of the “Memory Stick” is
insufficient.
• [MODE] (REC MODE) is set to [VOICE].
p Set the MODE dial to , P, or SCN (see the operating
instructions).
p Insert a “Memory Stick” (see the operating instructions).
p Set the write-protect switch to the recording position (see the
operating instructions).
p Delete the images saved in the “Memory Stick,” or format it
(see the operating instructions).
p Replace the “Memory Stick” (see the operating instructions).
p Set [MODE] (REC MODE) to a position other than [VOICE]
(see the operating instructions).
No request from the
desired device.
• The device (controller) is now connecting to
another device.
• You did not enter the passkey on the device.
• The device you intend to connect to is different
from the one selected.
• The device is not a BIP-compatible.
• The device is placed outside of radio wave
range.
• The antenna portion of your camera or the
device is covered with your hand etc.
• The camera ran past the time limit (about five
minutes).
p Connect the controller to your camera.
p Connect again and enter the correct passkey.
p Check the name on the SELECT THE RECEIVER screen.
p The camera can connect to only a BIP-compatible device
(page 4).
p Move the device closer to your camera.
p Do not cover the antenna portion (page 4).
p Set the camera so that it is connectable again (page 14).