Filter
Top Products
Miscellaneous
Messages
26
Other Messages
When the following message appears, the ALARM
indicator does not light. The PRINT indicator blinks.
REMOVE FILM TOP
& INNER:J6
The film has jammed around the front
or inside the unit.
tOpen the top cover, then the inner
cover and remove the jammed
film.(page 28)
REMOVE FILM
TRAY:J7
The film has jammed near the film
tray.
tPull out the film tray and remove
the jammed film.(page 29)
REMOVE FILM
SOME PLACES:J8
The film has jammed at several points.
tOpen all of the covers and remove
the jammed film.(page 29)
CALIBRATION
INVALID
The unit takes certain measurements to
estimate a value for automatic
calibration. However, the correct value
could not actually be measured. The
unit can print, but the automatic
calibration value is not updated.
tTry calibration again. If white strips
or scratches appear on the printout,
clean the thermal head and
rollers.(page 16)
MECHA TROUBLE
S nn
Mechanical trouble has occurred in the
sensor system of the unit.
tTurn off the power once and then
turn it on. The unit may operate
correctly. However, if the message
still remains on the LCD, turn off
the power immediately and contact
your Sony dealer.
MECHA TROUBLE
M nn
Mechanical trouble has occurred in the
motor system of the unit.
tTurn off the power once and then
turn it on. The unit may operate
correctly. However, if the message
still remains on the LCD, turn off
the power immediately and contact
your Sony dealer.
MECHA TROUBLE
U nn
Mechanical trouble has occurred in the
unit system of the unit.
tTurn off the power once and then
turn it on. The unit may operate
correctly. However, if the message
still remains on the LCD, turn off
the power immediately and contact
your Sony dealer.
DICOM TROUBLE Trouble has occurred in the DICOM
part of the unit.
tTurn off the power immediately and
contact your Sony dealer.
TAG INVALID Trouble has occurred in the IC tag part.
tTurn off the power immediately and
contact your Sony dealer.
Error messages Possible causes and remedies
Messages Possible causes and remedies
HEAD IN COOLING
PLEASE WAIT
The thermal head has overheated.
tLeave the unit until the head has
cools down and this message
disappears.
HEAD IN HEATING
PLEASE WAIT
The thermal head is warming up.
tLeave the unit until the head has
warms up and this message
disappears.
PLEASE WAIT The unit is retruning to the intial
settings to restart printing after closing
the covers which opened for removing
jammed film or cleaning.
tLeave the unit until this message
disapperas. When this message
appears, the PRINT indicator does
not blink.