Filter
Top Products
TV-IP262PI
TRENDnet User’s Guide
© Copyright 2012 TRENDnet. All Rights Reserved.
5
Installation
Hardware Installation
The camera can be mounted to the ceiling surface directly by following the steps below:
1. Remove the Dome cover by unscrewing the four screws.
2. Use the included drill template to drill three mounting holes on the desire location
and hammer the plastic anchors into the holes.
3. Secured the camera to the location with three screws.
4. Before put the Dome cover back, adjust the lens assembly by the following steps:
Tilt the camera lens to a proper position by losing the screws (
) and then
swinging the adjustable base (
).
Rotate the camera lens by turning the base pedestal (
) in either clockwise or
counter clockwise direction.
Adjust the lens focus by turning the lens ring slowly (
) in either clockwise or
counter clockwise direction.
NOTE: You can review the image quality from the Web browser when you complete the
installation. If the image quality is poor, you have to disassemble the Dome cover to
adjust the lens focus until the desired image appears clearly.
5. Put the Dome cover back and secure with four screws.