Filter
Top Products
Troubleshooting General/ Power Supply Verification - 30
not present, replace the power supply; otherwise, go to the
next step.
8. Connect the black lead of the volt meter to pin 16 of the power
supply connector for AGP and PCI models or pin 11 for Gigabit
Ethernet/DIgital Audio/QuickSilver/QuickSilver 2002 mod-
els. Connect the red lead of the volt meter to pin 4 of the power
supply connector. The volt meter should measure approxi-
mately +5V.
If you do not get a reading of +5V, re-check the volt meter
connections and measure the voltage again. If voltage is still
not present, replace the power supply; otherwise, go to the
next step.
9. Measure the voltage of pin 10 on the power supply connector.
The voltage should measure approximately +12V.
If you do not get a reading of +12V, re-check the volt meter