Filter
Top Products
31
10. Click the Home button to return to the home page while the new image setting acts on the
images to effect the desired changes instantly. (If the setting has not been changed by the
above steps, any (re)entry onto the home page will find images in their earlier or original
setting.)
Description of function keys:
Device Title: Type in the camera title in the given space.
Resolution:
MJPEG mode - Scroll to choose the image resolution from “352 * 240”, ”720 * 240”
or ”720 * 480” (NTSC); “352 * 288”, “720 * 288“ or “720 * 576“ (PAL).
H.264 mode - Scroll to choose the image resolution from “Full D1”,”Half D1” or “CIF”.
Quality: Scroll to choose the image quality out of a spectrum of qualities ranging from
“Highest”, ”High”, “Medium”, and “Low” to “Lowest”. In H.264 mode, you can also set
the quality by typing in the value. The custom quality value must be in the range
between 64 Kbps to 8192 Kbps.
Viewer type: Click to choose the viewer type of the “ActiveX” or “AJAX” mode.
Submit: Click to submit the new image setting to the IP Camera.
Frame rate: Click the drop-down list to choose the frame rates of “5FPS”,“15FPS”, “24FPS”
or “25FPS”.
Fine Tune mode:
White Balance: Scroll to choose the mode from “Auto”, “Fluorescent (3200K)”, “Indoor
(4200K)”, “Outdoor (6500K)”, ”Push Hold”.
Flickerless: Mark the “Flickerless” “ON” or “OFF”. Click your choices to enable.
Mirror: Mark the “Mirror” “ON” or “OFF”. Click your choices to enable.
High Speed Shutter: Mark the “High Speed Shutter” “ON” or “OFF”. Click your choices to
enable.
BLC Mode: Scroll to choose from “Disable”, “Weighted” or “Fixed Gain”.
Backlight: Select in the backlight level in the blank (0 to 255).
Brightness: Select your desired quality of image brightness from a spectrum of 0 to 255.
Contrast: Select the contrast level in the blank (0 to 255).
Saturation: Select the saturation level in the blank (0 to 255).
Sharpness: Select the sharpness level in the blank (0 to 255).
Videoalc: Select in the blank (0 to 255) to adjust the iris for different lighting environments.
Default: Click this button to install the default settings in all the entries for image
parameters on this page.