Filter
Top Products
150
C.Fn-09 Auto bracketing sequence / Auto cancel
You can change the AEB sequence when you bracket with the shutter
speed, aperture, or ISO speed. You can also change the white balance
bracketing sequence.
When “Auto cancellation” is set, bracketing will be canceled after you
change the lens or turn the <4> switch to <2>.
1: The first bracketed shot is the standard exposure (or exposed with
the standard white balance). This bracketing sequence can be
repeated.
2: Starts the bracketing sequence with the decreased level.
3: Repeats the bracketing sequence starting with the decreased
level.
C.Fn-10 AF point illumination
1: The AF point does not light at all. Effective when it is bothersome
to see it light up.
2: Prevents the dimmed lighting of C.Fn-10-0.
3:
Effective when the AF point lighting is difficult to see with C.Fn-10-0.
C.Fn-11 AF point selection method
1: This reverses the functions of the <S> button and <O> button.
2: ¡ While exposure metering is active, turn the <5> dial to select a
horizontal AF point. (If C.Fn-13-3 has been set, select a
peripheral AF point.) This is also possible while you press the
shutter button halfway and during continuous shooting with AI
Servo AF. The AF point selection stops at the extreme left,
extreme right, top-most, and bottom-most AF points.
¡ During autofocusing, you can press the <
S> button to switch
instantly to the automatic AF point selection mode.
¡ You can also select the AF point (including automatic AF point
selection) with the same operation as C.Fn-11-1.
¡ If both C.Fn-11-2 and C.Fn-18-1/2 (p.153) have been set, select
a vertical AF point by pressing the <O> button and turning the
<5> dial.
3: This reverses the functions of the <S> button and <I> button.