Filter
Top Products
162
If there is a problem, first refer to this Troubleshooting Guide.
¡ You are using the wrong battery.
s Use the dedicated Ni-MH Pack. (p.18)
¡ The battery is not properly attached to the charger.
s Attach the battery properly to the charger. (p.18)
¡ The battery is exhausted.
s Recharge the battery. (p.18)
¡ The battery is not installed properly.
s Install the battery properly. (p.20)
¡ The memory card slot is open.
s Push in the memory card and close the memory card slot. (p.24)
¡ If you set the <
4> switch to <2> right after shooting, the
access lamp will still light or blink for a few seconds while the
image is recorded onto the memory card.
s When the camera finishes recording the image to the memory
card, the access lamp will stop blinking and the power will turn off.
¡ The battery is not fully charged.
s Recharge the battery fully. (p.18)
¡ The battery’s service life has expired.
s Replace it with a new battery. (p.168)
Troubleshooting Guide
Power Source
The battery cannot be recharged.
The camera does not operate even when the <
4
> switch is set to <
1
>.
The access lamp lights or blinks even when the
<
4
> switch is set to <
2
>.
The battery becomes exhausted quickly.