Filter
Top Products
99
Editing
E
Connecting to a Computer Using a DV (IEEE1394) Cable
You can transfer recordings to a computer equipped with a DV (IEEE1394) terminal or
IEEE1394 capture board (optional software required).
❍ Operation may not work correctly depending on the software and the
specifications/settings of your computer.
❍ Do not disconnect the DV cable, open the memory card cover, remove the
memory card, change the position of the POWER switch or turn off the
camcorder and computer while data is being transferred to the computer
(while the camcorder’s card access indicator is flashing). Doing so may damage
the memory card’s data.
❍ The image files on your memory card and the image files saved on the hard
disk drive of your computer are valuable, original data files. If you wish to use
image files on your computer, make copies of them first, and use the copied
file, retaining the original.
❍ If the computer freezes while you have connected the camcorder, disconnect
and reconnect the DV cable. If the problem persists, disconnect the interface
cable, turn off camcorder and computer, turn camcorder and computer back
on and reconnect them.
❍ We recommend powering the camcorder from a household power source
while it is connected to the computer.
❍ Refer also to the instruction manual of the computer.
❍ Optional software is required for transferring recordings from the tape to a
computer. Refer to the instruction manual of the software.
❍ For transferring recordings from a memory card to the computer using a USB
cable, see p. 130.
❍ Users of Windows XP can use the DV Network Software contained on the
DIGITAL VIDEO SOLUTION DISK For Windows. For details, refer to the DV
Network Software Instruction Manual.
DV IN/OUT
IEEE1394 (DV) terminal
Commercially available DV cable
DV IN/OUT
terminal
6-pin
4-pin