Filter
Top Products
Appendix
135
If the LCD monitor (or viewfinder) displays the Date/Time menu when
you turn on the camera, this means that the date battery has run down
and the clock has stopped running. Please purchase a replacement
battery (lithium coin battery CR1220) and install it as follows.
1 Turn off the power and open the battery cover
(Basic Guide p. 1).
2 Remove the AA-size batteries,
then pull out the battery holder
by hooking your fingernail under
the bottom of the battery holder
edge.
3 Remove the old date battery and
place a new date battery into the
date battery holder with the
positive terminal (+) facing
upward.
4 Replace the date battery holder, replace the AA-size
batteries and close the battery cover.
5 Set the date and time when the Date/Time menu is
displayed on the LCD monitor (or viewfinder) (Basic
Guide p. 4).
Replacing the Date Battery
The date battery is preinstalled at the factory and may
therefore expire earlier than its rated lifespan after the camera
has been purchased.
Be particularly careful to keep the date batteries out of the
reach of children. Seek medical assistance immediately if a
child swallows a battery since corrosive battery fluids could
damage the stomach or intestinal wall.
Positive
terminal
(+)