Filter
Top Products
72
Single and continuous drive modes are provided. In the Basic Zone
modes, the optimum drive mode is set automatically.
1
Press the <R> button. (9)
2
Select the drive mode.
¡ While looking at the LCD panel, turn
the <6> dial.
u : Single shooting
When you press the shutter
button completely, one shot will
be taken.
i : Continuous shooting (Max. 5
shots per sec.)
While you press the shutter
button completely, shots will be
taken continuously.
j : Self-timer Operation (p.44)
iSelecting the Drive Mode
¡ During continuous shooting, the captured images
are first stored in the camera’s internal memory
and then successively transferred to the CF card.
When the internal memory becomes full during
continuous shooting, “buSY” will be displayed on the LCD panel and in
the viewfinder and the camera cannot take any more shots. As the
captured images are transferred to the CF card, you will be able to
capture more images. Press the shutter button halfway to check in the
viewfinder’s bottom right the current remaining shots of the maximum
burst.
¡ If “FuLL CF” is displayed in the viewfinder and on the LCD panel, wait
until the access lamp stops blinking, then replace the CF card.
¡ When the battery level is low, the maximum burst will be slightly lower.
Max. Burst