Canon HF S20 Camcorder Accessories User Manual


 
2 Touch the zoom controls to operate
the zoom.
Touch anywhere within the W area to
zoom out or anywhere within the T area
to zoom in. Touch closer to the center for
a slow zoom; touch closer to the _/li]l
icons for faster zooms.
3 Touch [X] to hide the zoom controls.
(_ NOTES
Keep at least 1 m (3.3 ft.) away from the subject. At full wide angle, you
can focus on a subject as close as 1 cm (0.39 in.).
In or mode, you can also set I-_/1_ _
[Zoom Speed] to one of three constant speeds (3 isthe fastest, 1 the
slowest).
When [Zoom Speed] is set to [_ Variable]:
- When you use the T and W buttons on the wireless controller, the
zoom speed will be constant at [_ Speed 3].
- The zoom speed will be faster in record pause mode than when
actually recording, except when pre-recording (CJ_]66) is activated.
QuickStart Function
When you close the LCD panel with the camcorder on, the camcorder
enters the standby mode. In standby mode the camcorder consumes
only about 1/3 the power used when recording, saving energy when
you are using a battery pack. Additionally, when you open the LCD
panel or pull out the viewfinder (1_ only), the camcorder is ready to
start recording in approximately 1 second*, allowing you to record the
subject right away.
* The actualtime requiredvariesdependingon theshootingconditions.
Operating modes: 1
1 With the camcorder on and in a recording mode, close the LCD
panel.
A beep will sound and the green ON/OFF (CHG) indicator will change
to orange to indicate the camcorder entered standby mode.
Dual Shot Mode * 47