Filter
Top Products
94
Using BEST SHOT
. Shooting with Prerecord CS
Half-pressing and holding the shutter button causes a pre-record buffer to be
continually updated with images. When the shutter button is fully pressed, buffer
contents are recorded along with a series of real-time images. Use Prerecord CS
when you want to make sure you do not miss fast-moving action.
1. In the BEST SHOT Mode, select “High Speed CS” (page 83).
2. Press [SET].
3. Use [8] and [2] to select the (High Speed CS fps) Control Panel
option and then press [SET].
4. Use [8] and [2] to select the continuous shutter (CS) speed you want
and then press [4].
• Use a higher “High Speed CS fps” setting when shooting a fast-moving subject.
5. Use [8] and [2] to select the (Maximum CS Shots) Control Panel
option and then press [SET].
6. Use [8] and [2] to select the maximum number of shots and then
press [4].
7. Use [8] and [2] to select the (Pre-record CS Shots) Control Panel
option and then press [SET].
8. Use [8] and [2] to select the number of Prerecord (Still) images and
then press [SET].
• Settings: 0 shots, 3 shots, 5 shots, 10 shots, 15 shots, 20 shots, 25 shots
• If you select “0 shots”, no pre-record images will be stored when you half-press
the shutter button.
Shutter button
half-press
Recorded images (up to 30 images)
Pre-recorded images
Shutter button
full-press
Shutter button
release
Continuous recording of images until shutter
button released