Epson R-D1 Digital Camera User Manual


 
Introduction 5
Do not store this product near water.
Do not store this product in a location subject to high temperature
or humidity.
Do not store this product in a location subject to rapid changes in
temperature or humidity.
Do not store this product in a location subject to direct sunlight or
strong light sources.
For United Kingdom, Hong Kong, and Singapore
users
Replace fuses only with fuses of the correct size and rating.
For United Kingdom users
Safety information
w
Warning:
Refer to the rating plate for voltage and check that the appliance voltage
corresponds to the supply voltage.
Important:
The wires in the mains lead fitted to this appliance are coloured in accordance
to the following code:
Blue - Neutral
Brown - Live
If you have to fit a plug:
As the colours of the mains lead of this appliance may not match coloured
markings used to identify the terminals in a plug, please proceed as follows:
The blue wire must be connected to the terminal in the plug marked with the
letter N.
The brown wire must be connected to the terminal in the plug marked with the
letter L.
If damage occurs to the plug, replace the cord set or consult a qualified
electrician.
FCC Compliance Statement for United
States Users
This equipment complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio or television reception. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause interference to radio and television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures.
Reorient of relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected
Consult your dealer or an experienced radio/TV technician for
help