Filter
Top Products
Getting Started 12
P-5000 User’s Guide
3. Set the date and time using the 4-way ring.
4. After you finish all settings, select Complete using the Right or Left key, then press the
OK key.
Note:
❏ If approximately 24 hours passes after battery power is cut, the date and time settings may be
lost, and will need to be set again.
❏ If the date and time settings are erased, the Date and Time screen is displayed when you turn
on the viewer next time.
❏ After changing the battery, make sure that the date and time is set correctly. If necessary, set
the date and time again.
❏ You can change the settings later. For details, see “Changing the Viewer Settings” (page 53).
Turning the power off
1. Make sure that the Access lamp is off.
2. Slide the power switch to as shown below and hold it down for several seconds until
the shut down display appears. The power switch will return to the original position.
Date and Time
Year
Date Format
Set current Date and Time.
MinuteHourDayMonth
2006 00121212
MM/DD/YYYY Complete
Hold
Illumination lamp