First Alert K5309-5V2 Security Camera User Manual


 
35
6FKHGXOLQJ
$ERXW6FKHGXOLQJ
The system provides end-user schedules (programmable by master/installer only),
which can control various types of events.
Each schedule causes a defined event to start and stop (when appropriate) at a
specified time.
Schedules can be set to automatically repeat at various intervals.
Schedules can be set for random starting, if desired.
FA168CPS provides up to 16 user schedules; FA148CP provides up to 4 user schedules.
&UHDWLQJ6FKHGXOHV
1.
+ [#] + [6] [4]
(Master Code)
Alpha Displays:
2.
Enter a 2-digit schedule number from:
01-16 (FA168CPS) or 01-04 (FA148CP).
Press [
] to continue.
=
3.
Enter the desired 2-digit event number from the
following list.
00 = clear the scheduled event
01 = turn a programmed output on or off
(see Using Device Commands section for a list of output device numbers used
in your system)
02 = set a user access schedule for one or more users
(see Security Codes section for an explanation of access groups)
03 = send a latch-key report to a pager if the system is not disarmed by a specified
time; message sent is 777-7777.
04 = automatically arm the system in STAY mode at a specified time
05 = automatically arm the system in AWAY mode at a specified time
06 = automatically disarm the system at a specified time
07 = Display the word REMINDER at a specified time
(if selected, the keypad will beep every 30 seconds beginning when the word
REMINDER is scheduled to display. To stop the beeps and cancel the
display once it starts, simply press any key.
Press [
] to continue.
4. For event number 01, enter the output number
associated with this schedule.
Otherwise, this prompt is skipped.
Press [
] to continue to the Start prompt below.