Filter
Top Products
103102
i The voice memo file is faulty.
i Camera fault.
i The voice memo cannot be played back.
i Contact your FUJIFILM dealer.
CCD-RAW is set to ON in SET
–
UP. Set CCD-RAW to OFF in SET
–
UP (➡P.73).
The timing for recording was incorrect
because the xD-Picture Card was
formatted on a computer.
Use an xD-Picture Card that was formatted
on the camera.
Warning Displayed Explanation Remedy
Camera malfunction or fault.
i Switch the camera on again, taking care not
to touch the lens.
i Switch the camera off and on again.
Warning Displays
Prints were specified for more than
1000 frames in the DPOF frame
settings.
The maximum number of frames for which
prints can be specified on the same xD-
Picture Card is 999.
Copy the images for which you want to order
prints onto another xD-Picture Card and then
specify the DPOF settings.
Troubleshooting eIf you think the camera is faulty, check the following once more.
Troubleshooting Possible causes Solutions
No power.
Power cuts out during
operation.
Batteries run out
quickly.
No photograph is taken
when the Shutter button
is pressed.
The flash settings are
restricted and cannot
be selected.
Can’t set exposure
compensation.
Can’t use the flash to
take pictures.
I can only select
“Suppressed Flash”
Flash mode.
Can’t select the “
5
”
quality settings.
The playback image is
too dark even though
the flash was used.
The image is blurred.
i The batteries have run out.
i The batteries are loaded backwards.
i The battery cover is not closed properly.
i The AC power adapter plug has come
out of the power outlet.
The batteries run out.
i You are using the camera in extremely
cold conditions.
i The terminals are soiled.
i The batteries get un-rechargeable.
i No xD-Picture Card is inserted.
i The xD-Picture Card is fully recorded.
i The xD-Picture Card is not formatted.
i The xD-Picture Card contact area is
soiled.
i The xD-Picture Card is damaged.
i The camera was not used for 2 minutes.
i The batteries run out.
Scene position mode is selected.
The Photography mode is set to Auto,
Scene position or Manual.
i The flash is set to Suppressed flash
mode.
i You pressed the Shutter button while the
flash was charging.
i The batteries run out.
Continuous shooting is selected.
i The sensitivity is set to 800 (high-
sensitivity photography) in the
Photography menu.
i The continuous shooting option in the
Photography menu is set to “Long-period
Continuous Shooting”.
i The subject is too far away.
i Your finger was covering the flash/flash
control sensor.
i The lens is dirty.
i The photographed subject was too dark.
i You photographed scenery with Macro
mode selected.
i You took a close-up shot without
selecting Macro mode.
i You are shooting a subject that is not
suited to autofocusing.
i Fit new or fully charged batteries.
i Load the batteries in the correct direction.
i Close the battery cover correctly.
i Plug the adapter back in.
Fit new or fully charged batteries.
i Put the batteries in your pocket or another
warm place to heat it and then load it into
the camera just before you take a picture.
i Wipe the battery terminals with a clean,
dry cloth.
i Fit new batteries.
i Insert an xD-Picture Card.
i Insert a new xD-Picture Card or erase
some unwanted frames.
i Format the xD-Picture Card.
i Wipe the xD-Picture Card contact area
with a clean dry cloth.
i Insert a new xD-Picture Card.
i Switch the camera on.
i Fit new or fully charged batteries.
The flash settings are restricted because
the camera settings are tailored to the
scene being shot. Change the
Photography mode for a wider range of
flash settings.
Change the Photography mode.
i Set the flash mode to Auto, Red-eye
reduction or Forced flash (The flash
cannot be used in some modes).
i Wait until charging is completed before
pressing the Shutter button.
i Fit new or fully charged batteries.
Set continuous shooting to OFF.
i In the Photography menu, set the
sensitivity to 400 or less.
i Set the continuous shooting option to
something other than “Long-period
Continuous Shooting”.
i Move to within the effective flash range
before taking the shot.
i Hold the camera correctly.
i Clean the lens.
i Try standing approx. 2 m (6.6 ft.) from
your subject to take the picture.
i Cancel Macro mode.
i Select Macro mode.
i Use AF/AE lock to take the shot.
A protected file was encountered. Protected files cannot be erased. Remove the
protection.
i The data could not be recorded due
to an xD-Picture Card error or a
connection error between the xD-
Picture Card and camera.
i The photographed image cannot be
recorded as it is too large to fit in the
available space on the xD-Picture
Card.
i Re-insert the xD-Picture Card or switch the
camera off and then on again.
i Use a new xD-Picture Card.
An attempt was made to specify DPOF
settings for an image that is not
supported by DPOF.
DPOF printing cannot be used with this image
format.