Filter
Top Products
110
Troubleshooting Possible causes Solutions
Nothing happens when I
use the Mode switch.
i Camera malfunction.
i The battery exhausted.
i Briefly remove the batteries or
disconnect the AC power adapter. Then
reload the batteries or reconnect the AC
power adapter and try again.
i Purchase new batteries.
When the camera is
connected to a personal
computer (PC), the shot
image appears on the
camera’s LCD monitor.
i The special USB cable is not connected
correctly to the PC or camera.
i The PC is not switched on.
i Set up the camera and USB cable
correctly.
i Switch the PC on.
The camera no longer
works correctly.
i The camera has suffered an unforeseen
problem.
i Remove the batteries briefly and then
reload the batteries and try again.
The ERASE ALL function
does not erase all the
frames.
Frame erase does not
erase the frame.
i Some frames may be.protected. i Unprotect frames using the camera on
which the protection was first applied.
Troubleshooting
eIf you think the camera is faulty, check the following once more