FujiFilm S3000 Digital Camera User Manual


 
25
2
Frame the shot so that the subject fills the entire
AF (Auto Focus) frame.
!
The image shown on the screen before taking the
shot may differ in its brightness, color, etc. from the
image actually recorded. If necessary, play back the
recorded image to check it (P.38).
!
In some conditions it may be difficult to see your
subject clearly on the LCD monitor (Such as in
sunny weather outdoors). In such situations, use the
viewfinder (EVF) to take the shot.
!
If the subject is not in the AF frame, use AE/AF lock
to take the picture (P.29).
6
Bebeep
7
When you press the Shutter button down halfway, the
camera emits a short double-beep and focuses on your
subject (the indicator lamp (green) changes from
blinking to steady). At that point, the AF frame on the
screen becomes smaller and the camera sets the
shutter speed and aperture.
!
If the camera does not emit a short double-beep and “V
appears on the screen, the camera cannot focus.
!
When you press the Shutter button down halfway, the image
on the screen freezes temporarily. However, this image is not
the recorded image.
!
If “V” is displayed on the screen (e.g. the shot is too dark
for the camera to focus), try standing about 2 m (6.6 ft.) from
your subject to take the picture.
7
24
To zoom in on the subject, press “a” (T TELE
Zoom). To zoom out, press “b” (W WIDE Zoom).
A “zoom bar” appears on the screen when you
zoom in or out.
hOptical zoom focal length (35mm camera
equivalent)
Approx. 38 mm-228 mm
Maximum zoom scale: 6×
!
Zooming pauses briefly when it switches between
optical zoom and digital zoom (P.32). Press the
same zoom button again to switch zoom modes.
4
Zoom bar
Loop the strap over your wrist, brace your
elbows firmly against your body and hold the
camera with both hands.
Be careful to ensure that the lens and flash
control sensor are not obscured by your hands
or the camera strap.
!
The image will be blurred if the camera moves when
taking the picture (camera shake). Use a tripod to avoid
camera shake, particularly for shots in dark locations
when the flash is set to Suppressed Flash mode.
!
There may be some unevenness in the brightness at the
lower edge of the LCD monitor. This is normal and does not
indicate a fault. This does not affect the photographed image.
4 5
TAKING PICTURES
(
AUTO MODE
)