Hasselblad 70380554 Digital Camera User Manual


  Open as PDF
of 140
 
53
H4D
Note
General sensor unit care
•
Time & Date settings on the sensor unit (which are included with les and batch labels) are updated automatically through a
FireWire/Phocus connection. These settings are retained for about two consecutive weeks by a small rechargeable cell that is auto-
matically recharged by the main battery or FireWire with regular use. If problems occur, charge the cell by leaving the sensor unit
turned ON for around 12 hours.
•
Do not touch the exposed CCD/lter with your ngers.
•
Always replace the protective CCD/lter cover when the sensor unit is not mounted on a camera.
•
Never attempt to remove the glass lter from the front of the CCD–you will probably ruin the CCD if you do so. If dust manages to
get between the IR lter and CCD, it can only be removed at the Hasselblad factory. Contact your Hasselblad dealer for assistance.
•
Store the sensor unit away from moisture and excessive heat.
•
When cleaning the lter, take at least as much care as you would with any optic. See later section in this manual for cleaning
instructions .
Approval/(OK)button F
This button steps throughthe three approval levels,
thereby assigning an approval status to the image
currentlydisplayed(orselected)inthepreviewscreen.
(partoftheInstantApprovalArchitecturesystem).Alsoactsasaconr-
mationbutton(OKbutton)forsometypesofmenuoperations,suchas
deletingimages;indicatedbyalabelbesidethebuttononthepreview
screen.
Busy-light G
Flashestoindicatethatthesensorunitisperforminganoperation
(suchassavinganewcapture).Althoughanewcapturecannotbe
madewhilethelightisashing,focusing,apertureandshutterspeed
settingscanallbechanged.
Redsigniesaproblem(anexplanatorymessagewillbedisplayed).
Safety catch H
Usedwhenremovingthesensorunit.
CCDandIRlter I
The sensor is positioned behind a permanently mounted IR lter.
Alwaysbeverycarefulnottotouchorscratchthesurfaceofthelter
whenitisexposed.
Replacetheprotectivecoverwheneverthesensor
unitisnotmountedonacamera.
Databus connectors J
Fordigitalcommunicationwithcamerabody.
Flash-card slot K
Flash-card removal button L
Flash-card slot cover M
(H4D-31 / 40 / 50 only)
Flashsyncinput N
Flashsyncconnector(protectedbehindarubbercover)forwhenthe
sensorunitisusedwithaview/largeformatcamera.
Flashsyncoutput O
Flashsyncconnector(protectedbehindarubbercover)forwhenthe
sensorunitisusedwithaview/largeformatcamera.
FireWire connector P
FireWire800portforcomputerconnection.
(H4D-60 only)
Flash sync & power connectors Q
Connectors(protectedbehindarubbercover)usedwhenthesensor
unitismountedonaview/largeformatcamera.
FireWireconnector R
FireWire800portforcomputerconnection.
 previous next