Filter
Top Products
Chapter 6: Using the Setup Menu 119
1 In the Setup Menu (page 115), select Date & Time.
2 In the Date & Time sub-menu,
adjust the value of the highlighted
selection by using the
buttons.
3 Press the buttons to move to
the other selections.
4 Repeat steps 2 and 3 until the
correct date/time format, date, and time are set.
5 Press Menu/OK to save the setting and return to the Setup
Menu.
The new setting remains in effect until it is changed again, even
when you turn the camera off.
USB Configuration
This setting determines how the camera is recognized when
connected to a computer.
1 In the Setup Menu (page 115),
select USB.
2 In the USB Configuration
sub-menu, highlight one of these
two choices:
•
Digital Camera—Causes the
computer to recognize the camera
as a digital camera using the Picture Transfer Protocol (PTP)
standard. This is the default setting on the camera.
• Disk Drive—Causes the computer to recognize the camera as a
disk drive using the Mass Storage Device Class (MSDC)
standard. Use this setting to transfer images to a computer that
does not have the HP Image Zone software installed on it (see
Transferring Images to a Computer without HP Image Zone
Software on page 126). This setting may not work with a